 |
LIGHT CHANNEL 700 |
Features
Light Channel is an extruded aluminum profile designed to
provide several alternative light sources from one linear system. It is supplied in
standard 12 foot lengths and requires a minimum of only two supports per length. A
complete architectural lighting system can be supplied with minimal supporting hardware.
Thus a 12 foot square 48 linear feet would require only eight supports. In addition to
providing much cleaner lines than traditional track and fixtures, there is a greater
choice of illumination sources. Each Light Channel system is manufactured to your
specifications. Available finishes range from standard silver aluminum powder coating to
grained and anodized finishes.
 |
| Shown: Light Channel with low voltage halogen
spots on the left and fluorescent tubes on the right and a flexible connector between
them. |
LIGHT SOURCES
- Low voltage halogen spots are recessed into the channel and
provide rotation on two axes. These take an MR16 lamp, 75 watts maximum.
- For uplighting, two 50 watt xenon bi-pin lamps based on our
Lux 10 fixture are used (see page 22).
- Single T5 Fluorescent lamps and ballasts are housed within
the channel. We suggest the use of high output lamps.
| 24 watts |
21.6" (549mm) |
| 39 watts |
33.4" (849mm) |
| 55 watts |
45.2" (1149mm) |
| 80 watts |
57" (1449mm) |
Such are the advances in lamp technology that all three
light sources can now be specified with 10,000 hour lamps.
 |
| Shown: Light Channel with T5 fluorescent
lamps and end cap |
LIGHT CHANNEL |
