architecture - engineering - construction
Translite Systems
Translite Systems
Translite Systems - Page 3
Translite Systems
 |
 |
DIRECTIONAL
WAND WITH WALL ANCHOR
Allows Cable to change direction. Includes Turnbuckle and 36" (1m) of cable.
Typically wall mounted. Anchor base is ø 1.0" 25mm). Does not require isolator
plates when mounted to a metal surface. |
Natural Alum. |
CA-346-AL |
| Bright Nickel |
CA-346-NK |
| Brass / Copper |
CA-346-BR/CU |
 |
 |
DELUXE
DIRECTIONAL WALL BRACKET
Allows Cable to change direction on the plane perpendicular to the mounting
surface. Typically wall mounted. Base is ø 4.0" (100mm). |
4",
Natural Alum. |
CA4-344-AL |
| 4",
Bright Nickel |
CA4-344-NK |
| 4", Brass
or Copper |
CA4-344-BR or
- CU |
| 6",
Natural Alum. |
CA6-344-AL |
| 6",
Bright Nickel |
CA6-344-NK |
| 6",
Brass/Copper |
CA6-344-BR/CU |
 |
 |
CEILING
TURNBUCKLE HARDWARE SET
Anchors and tensions Cable from both ends of span. Recommended for spans over
35'. Holds cable 6" (150mm) off mounting surface (usually a ceiling). Bases are ø
3.5" (89mm). This set does not allow for an integral power feed. Use Power Bolts
(CA-507) or a Power Canopy set (CA-509). |
|
Complete Set |
Natural Alum. |
CA-316-AL |
| Complete Set |
Bright Nickel |
CA-316-NK |
| Complete Set |
Brass / Copper |
CA-316-BR/CU |
| Turnbuckles at
both end of the run. 
|
|
N.B. Use isolating
plates # CA-812 when mounting anchors to a metal surface. |
 Isolating Plates |
Complete Set |
Clear |
CA-812 |
CABLE SYSTEMS |