LAV Guard (TRUEBRO)

Installed Cross-Section

A	Install Accessory #105 cover on offset wheelchair strainers (Accessory #105 can be purchased separately or is included in model #103 kits)
B	Snap-Clips supplied for all fastening slots
C	Follow trim lines on inside of cover to ensure square cuts
D	Release latch Snap-Clip before opening Lock-Lid
E	Install cover over compression nut and up supply tube
F	Latch Snap-Clip
G	Trim Waste Arm length to escution
H	Follow calibrated trim marks located inside of covers when cutting to ensure a square fit
I	Note: Only release cleanout access cap when necessary for trap servicing

Canadian and U.S. Patents:

5,054,513	5,454,392
5,163,469	5,524,669
5,259,410	5,540,255
5,303,730	1,424,032
5,360,031	78,511
5,419,364	Pat Pending

Truebro warrants its products against defective material and manufacture (but not defective installation) for one year after installation. Truebro's liability under this warranty shall be limited to the repair or replacement of the defective product. There shall be no other remedy available, including without limitation, recovery for incidental or consequential damages, injury to person or property, or any other incidental or consequential loss.

The warranty described above shall be IN LIEU OF any other warranty, express or implied, including without limitation, any implied warranty of MERCHANTABILITY or fitness for a particular purpose.

Some states do not allow the exclusion or limitation on the period of warranty or incidental or consequential damages, so the above limitations may not apply to you.

7 Main Street
P.O. Box 440
Ellington, CT 06029

For Technical Assistance
1-800-340-5969

LAV Guard Page - 3