Unimast Products (Unimast Inc.)

RS - Rolled Strapping

				NUMBER OF SCREWS ON EACH FLANGE
			SCREW	NECESSARY WHEN FASTENED TO:				ALLOWABLE LOADS
PRODUCT	GAUGE	SIZE	SIZE	22ga	20ga	18ga	16ga	FLOOR & ROOF	UPLIFT
RS150	16	1-1/4"X150'	#10	11	8	5	4	1230	1645
RS200	18	1-1/4"X200'	#10	8	6	4	4	950	1270
RS250	20	1-1/4"X250'	#10	7	5	5	5	755	1010
RS300	22	1-1/4"X300'	#10	6	6	6	6	625	835

Uplift loads have been increased 1/3 for wind or earthquake. No further increase is allowed.

PRODUCT FEATURES

Available in four gauges resisting up to 1645 pounds.
Installs with #10 screws.
Product code stamped every 6 inches for easy identification.
Cartons fit easily behind pick-up truck seats or in car trunks.
Cut on jobsite to any convenient length.
Versatile, this strapping can be used to resist tension forces caused by wind or earth quake.
Each carton weighs about 40 pounds.
Screw spacing may be 1-1/4, 2-1/2 or 3-3/4 inches on center.

This unique steel truss framing was developed over a two year period. Rigorous standards were set by the engineering team for product design and performance. The complete system underwent exhaustive laboratory and field tests before it was released to the market. It is strong, lightweight and simple to build, with design software in place to support layout and engineering.

TrusSteel^™ provides superior strength. Its roll formed lip allows the raw material to lay flat. As a result finished trusses stack flat and band easily. The flange design avoids dangerous sharp edges and virtually eliminates damage to objects pulled through the trusses.

Making the steel simple to build was an engineering challenge. Our Research and Development Team designed a double shear screw that speeds fabrication by allowing the truss to be assembled from just one side.

Design software was developed to assure the system works as well for residential construction as it does for commercial projects. Design freedom and engineering accuracy are the hallmarks of this new system.

For more information on how you can take full advantage of this product on your next project, call:

Alpine TrusSteel Division in Grand Prairie, Texas, (800) 755-6005.

WARRANTY

Alpine Engineered Products, Inc. warrants that, after reasonable notice in writing delivered to its home office at 1200 Park Central Blvd. South, Pompano Beach, Florida 33064, and after reasonable opportunity to inspect, it will repair or replace without charge, any product manufactured by Alpine which, upon inspection, is found by Alpine to have been defective at the time of delivery by Alpine. This warranty does not apply in the event the products have been altered, damaged, installed improperly, or misused in any manner after delivery by Alpine. This remedy shall constitute Alpine's sole obligation and purchaser's sole remedy under this warranty. In no event will Alpine be responsible for incidental, consequential, or special loss or damage regardless of cause. Products sold, but not manufactured, by Alpine shall be subject to the warranties of the respective manufacturers. The warranty described in this paragraph shall be in lieu of any other warranty, express or implied, including but not limited to, any implied warranty of merchantability or fitness for a particular purpose, all such other warranties being hereby expressly excluded.