 DESCRIPTION
Vitricolor EVOC is a low, odor polychromatic coating
consisting of polymers containing colored particles suspended in an environmentally
friendly aqueous medium. Vitricolor EVOC is sprayed by a conventional sprayer at
high volume low pressure.
USES:
Vitricolor EVOC can be used on interior or exterior
architectural surfaces. It is a seamless coating with superior durability and esthetic as
conventional vinyl wallpaper.
ADVANTAGES:
VOC Compliant in California
Seamless
Durable
Aesthetically Exciting
Available in matte and glossy options
SURFACE PREPARATION:
Standard procedures normal to the painting professions for using
conventional paint products should be followed. Vitricoat Primer should be used on
exterior masonry surfaces. When coating over a different existing coating use Vitricoat
Primer and Vitricolor instead of two coats of Vitricolor.
Exterior chalking surfaces should be sandblasted. Clean all interior
glossy surfaces with a detergent to remove dirt, grease, and debris. Bare metal must be
primed with Polyseal ZC Primer, a rust inhibiting primer. Bare wood must be primed
with an oil type wood primer or enamel undercoater. On drywall; use Vitricoat Primer
to eliminate telegraphing of joints. On masonry block walls use Vitricoat Primer to
fill pores and voids.
APPLICATION:
The substrate must be clean and free of contaminants. Vitricolor
EVOC can be sprayed with a Binks 2001 with cup at incoming pressure of 10-15 psi, pot
pressures of 3-5 psi. The tip at the nozzle can be a 66 SD type.
Always run water through the spray equipment prior to the
application of Vitricolor EVOC. Shake pail gently periodically to facilitate
spraying. Product should be stirred slowly prior to application.
Do not mix at high speed as this will destroy this product.
| PROPERTIES |
| Weight per gallon |
9.2 lbs. |
| Odor |
None to very slight |
| Flash Point |
Above 200º F |
| VOC |
1.63 gm/l |
| Viscosity |
15-30 Kps |
| Scrubbability |
Resists 600 rubs |
| Accelerated Weathering |
Passes 2,000 hours |
LIMITATIONS:
KEEP from freezing
Do not apply to damp surfaces.
Surface temperature must be above 50º F.
| COVERAGES: |
|
PACKAGING |
| Vitricoat Primer |
200 sq. ft per gal. |
5 gallon units |
| Vitricolor EVOC |
100-125 sq. ft per gal. |
5 gallon units |
| Vitricolor EVOC Sealer |
200 sq. ft. per gal. |
5 gallon units |
| Epoxy Glaze |
200 sq. ft per gal. |
5 gallon units |
| * Coverage can vary depending on substrate
profile. |
COLORS:
From Vitricolor Color Chart
CAUTION:
If swallowed contact a physician immediately.
Consult Manufacturers Safety Data Sheets
Vitricon® Inc.
65 DAVIDS DRIVE
HAUPPAUGE, NY 11788
(516) 231-1300 | (800)777-6596
FAX (516) 231-1329 |
