Your plant's curing requirements are DIFFERENT

And so are the Welden Steam Generators!

Five different single stage models:

Ranging from 700,000 to 5,000,000 BTU's per hour. Best suited for the plant curing one area at a time. Can be manually controlled or automatically, through the use of a control panel.

Two different three stage models:

Model 3S10 - 360,000 or 720,000 or 1,080,000 BTU's per hour. Model 3S15 - 500,000 or 1,000,000 or 1,500,000 BTU's per hour. Best suited for the plant curing more than one area at the same time. Can be manually controlled or automatically, through the use of a control panel.

Three different seven stage models:

Model 7S25 - Starting at 360,000 and staging up in like increments to a full output of 2,520,000 BTU's per hour. Model 7S35 - Starting at 500,000 and staging up in like increments to a full output of 3,500,000 BTU's per hour. Model 7S250 - Starting at 720,000 and staging up in like increments to a full output of 5,000,000 BTU's per hour. Best suited for the plant curing several areas in rotation or requiring different amounts of steam for various curing areas. These generators work automatically through pressure control. As valves are opened or closed, the unit matches the output to the load demand.

Our goal was to develop a more efficient direct fired system than any other on the market today. Designed to operate with approximately half the electrical H.P. per BTU output (compared to equivalent models) with NO throttling or dumping of excess air at lower outputs. Welden affords you an economical advantage you can see.

Welden Steam Generators make the difference!

Find out more about the Welden advantage by contacting:

122 E. Rocksylvania Ave.
Iowa Falls, IA 50126
515-648-3021
1-800-446-2334
Internet Address: http://www.greenbelt.net/welden 
Email: welden@cnsinternet.com