A member of the Yale Security Group
Yale 5300 Locksets are supplied with a standard strike; a
variety of optional strikes are also available. All strikes are located on the same
vertical and horizontal center lines as the latchbolt. Some strikes are available in a
variety of lip length to accommodate varying thickness of doors and frames. To determine
the proper length of the lip, measure from the center line of the jamb add 1/4''. All
strikes are reversible.
Standard Strike
List No.371 x 1-1/4'' Lip supplied standard with 5300
series Locksets except when rabbeted latchbolt is ordered. This strike will accommodate
frames for 1-3/8'' to 1-3/4'' thick doors. Strikes with other lip dimensions shown
are available to special order. All List No 371 strikes are supplied with Wrought Strike
Box Part No. 14 5301-1033.
Standard Rabbeted Strike
List No. 371-1/2'' x 1-1/4'' Lip supplied standard with all
5300 Locksets when ordered with rabbeted latchbolts. Consists of a 371 Strike, a List No.
374 Trim (Part No. 14-5301-2261) with attaching screws and a wrought Strike Box.
Accommodates doors 1-3/8'' to 1-3/4'' thick. Strikes with other lip lengths are available
to special order. To order a complete lockset for rabbeted doors suffix ''1/2'' to the
lockset List No. and specify whether wood or metal door, i.e. CA5307-1/2 26D x wood.
Raised Lip Strike
Optional List No. 371A is available to special order. The
raised lip provides an additional projection of the strike to engage the latch- bolt when
the gap between the door and jamb is more than 1/8''. Specify lip length on the order.
Wrought Strike Box Part No. 14-5301-1033 furnished standard with this strike.
Protected Back Strike
Optional List No. 431 available to special order. This
strike provides extra security against forcing the latchbolt out of the strike. This
strike also serves as a stop on double doors that are not rabbeted. Specify lip length on
the order, 15/16'' for 1-3/8'' thick doors, 1-1/4'' for 1-3/4'' thick doors.
Ansi Strike
Optional List No. 497 for door and frames with ANSI A115.2
preparations.
Strikes are fabricated of either brass, bronze or
stainless steel depending on the lockset trim finish.
When ordering strikes separately, specify the
finish required. |
