SPECIFICATIONS
PART 1 - GENERAL
1.01 DESCRIPTION OF WORK
Extent of the canopies required is shown on the drawings. Included herein, but not limited to.
are decking, fascia/gutter, columns, anchors, supports, and flashing.
1.02 MEASUREMENTS
Verity all dimensions shown on drawings by taking field measurements to insure proper fit
and attachment of all component parts.
1.03 SUBMITTALS
Provide manufacturers shop drawings, including fabrication and installation details. 1.04
1.04 COORDINATION
Provide necessary anchors, blockouts, flashing and other items required to be built-in in
ample time to avoid delays to the job.
1.05 DELIVERY& STORAGE
Deliver and store all items in protected areas. Keep free of any damage. Replace any
damaged items or parts at no cost to the Owner.
1.06 DESIGN PARAMETERS
Live load of the canopies shall be no less than 20 p.s.f. Canopies shall comply in all
respects with Southern Building Code Congress international requirements for Floor, Wall &
Roof systems.
PART 2 - MATERIALS AND PRODUCTS
2.01 ACCEPTABLE MANUFACTURER
Subject to compliance with requirements herein, provide product manufactured
by SuperiorMetal Products Company, Birmingham, Alabama.
2.02 PRODUCT AND MATERIALS:
(Consult Superior Metal Products' Architect Manual and design staff for detailed
specifications of materials and products.)
PART 3 - INSTALLATION AND ERECTION 3.01
3.01 INSTALLATION
Canopies shall be installed according to approved plans and shop drawings and the entire
structure shall be erected straight, true, and plumb in accordance with standard construction
procedures. All joints and connections shall be tight and clean, and all surfaces of work left
in a clean condition.
