Signature Section 08350. CSI 3-Part Specifications.

PRODUCT SPECIFICATIONS: SECTION 08350 - FOLDING DOORS

PART 1 GENERAL

(See Project Guide Specifications for Scope, Related Work, References, Submittals, Product Delivery and Acceptable Manufacturers paragraphs)

PART 2 PRODUCTS

2.1 FOLDING DOORS shall be manually operated wood, folding type as manufactured by Panelfold, Inc., Miami, Florida, U.S.A. and installed by an authorized representative of the manufacturer in openings prepared by others to Signature requirements.

2.2 TRACK AND HANGERS: Track shall be extruded aluminum, Hanger assemblies with two nylon wheels shall be suspended on alternate panels. A four-wheel truck hanger assembly shall be installed on each end post.

2.3 PANEL SURFACES: Panels shall be specially laminated engineered wood core, bonded with water-resistant, plastic glue and surfaced with one of the following: (colors to be selected from manufacturer's standards):

2.3.1 Woodtex Class A flame spread wood T. grain vinyl shall be specify: Honeywood Wheatwood or Sablewood
2.3.2 Frostex White solid color vinyl, Class A flame spread,
2.3.3 Genuine wood veneer shall be (specify: clear lacquer finished; unfinished, sanded ready for field finishing by others; factory specially finished to match owner's submitted sample) species as specified: White Ash, Red Oak, White Maple; or American Walnut.

2.4 CONNECTOR MOULDINGS: Panels shall be connected by shaped mouldings of the same surface and color as the panels.

2.5 TRIM: Doors shall be supplied with (specify: decorative track; optional plain track with track mould to conceal track; or optional plain track with extruded aluminum sub-channel for recessed track). A jamb mould for jamb closure shall be furnished.

2.6 CURVED TRACK, SWITCHES, AND MULTIPLE MEETING POSTS: Furnish to effect room division as detailed on the plans. Minimum radius 3'0" (914mm).

2.7 HARDWARE: Handles, Touch-Bar automatic latches, all necessary screws, installation hardware and instructions shall be furnished. Security units shall be as specified: Privacy latch and emergency release; cylinder lock one side only, cylinder lock one side, privacy lock other; cylinder lock two sides. Optional. Master-keyed insert type cylinder with lazy cam and flat tail piece, by others, shall be installed in lieu of regularly furnished cylinder.

2.8 STACK FORMULA: Approximately 1 -/ft. (82mm/m) plus 3" (76mm) for each end post assembly.

2.9 HANGING WEIGHT: Approximately 1.7 lbs./ft2 (8kg/m2).

PART 3 EXECUTION

(See Project Specifications Guide for Execution, Inspection, Preparation, Installation, Cleaning and Demonstration paragraphs.)

NOTE: The ASTM  84 procedure Class A flame spread and other test results referenced herein are for comparison purposes only and are not intended to reflect hazards presented by this or any other materials under actual fire conditions.

Panelfold^®
FOLDING DOORS - ACOUSTICAL FOLDING PARTITIONS - OPERABLE WALLS - RELOCATABLE WALLS
Panelfold, Inc. PO Box 680130 Miami, Florida 33168
305/688-3501 - FAX: 305/688-0185
Panelfold is constantly developing its products and reserves the right to change specifications without notice. Copyright© 1998 by Panelfold, Inc. All rights reserved.