architecture - engineering - construction
Printable version Bookmark this page Notify a colleague or friend about this page Bookmark and Share

TotalFlash Masonry Cavity Wall Drainage Solution


The patented TotalFlash® Cavity Wall Drainage Solution is a complete, factory-assembled masonry cavity wall flashing system. It combines a flashing membrane with a mortar dropping collection drainage mesh, drainage mesh weep tabs, drip edge and termination bar into a single, easy-to-install panel. It provides superior moisture protection, slashes labor costs, and can be custom configured for your job, usually at no additional charge.

 Key Features

  • Available in both 50’ rolls and boxes of 10 pre-assembled 5’ 6” panels. (5’ net/panel, 50’ net/box)
  • Pre-assembled panels are a complete drainage system and consist of a flashing membrane, a mortar dropping collection mesh, drainage mesh weep tabs, drip edge and termination bar  
  • 50’ rolls consist of the integrated flashing membrane, a mortar dropping collection drainage mesh, and drainage mesh weep tabs. (Drip edges, termination bars, and termination bar mounting screws sold separately)
  • On 50’ rolls, air- and water-tight lap joints or termination points may be formed with minimal waste at any point along the membrane
  • 14" High inside/outside preformed corner boots and end dams, pre-formed metal 90° outside drip edge corners, metal adjustable drip edge corners and sealant sold separately
  • Mortar dropping collection drainage mesh and weep tabs for all TotalFlash configurations are 90% open-weave polyester mesh
  • Standard height for panels and rolls is 18”. Additional available sizes are 12”, 24”. (Custom sizes are available on request)
  • FREE takeoff service and custom panel sizing

Included in each 10-panel box:

  • 1 starter strip for left-to-right installation
  • 100 self-tapping termination bar mounting screws
  • Available component options for panels and rolls:
    • Membranes: Thermoplastic Vinyl, Rubberized Asphalt, Copper Laminate, TPO, EPDM
    • Drip edges: Stainless Steel, Cold-rolled Copper, Kynar®-coated galvanized steel in 4 colors (Almond, Tan, Gray, Terra-cotta), or no drip edge
    • Termination bars: PVC, Stainless Steel, or no termination bar

Key Benefits:

  • Proven to cut installation time by at least 50% when installing panels vs. standard flashing pieces and parts
  • FREE takeoff service guarantees delivery of the right types and quantities of TotalFlash and components
  • One stop shopping means no job slow-downs waiting for separate items to be delivered
  • Rolls may be purchased with or without components to match any job requirement
  • Significant reduction in flashing installation time and expense on large projects by using 50’ rolls for long runs combined with pre-assembled panels custom-sized for repetitive openings
  • Proven overlap and termination method quickly and easily creates air- and water-tight lap joints and terminations when using TotalFlash panels or rolls
  • Integrated weep tabs will not clog from mortar droppings and prevent insects from entering the cavity
  • Panels and rolls are lightweight and easy to handle, even on scaffolding
  • Panels and rolls are highly adaptable to restoration projects with a variety of standard and custom sizes
  • Multiple drip edge options enhance the appearance of nearly any design
  • Clear instructions, extensive product support, simple, fast installation and high quality materials helps assure leak-proof installations to specs

For other relevant searches, you might want to try:

(04 - 16 Div.) Masonry
(04) Masonry